Page 1 of 1

DroneMesh PCB for RapidFire

Posted: Fri Nov 22, 2019 7:22 pm
by Wojked

I just saw the video on YouTube about your PCB for rapidfire!

I think it has a huge potential, I believe that a cheap DIY dock for Fatshark modules has always been needed!

I have designed a dock I used as a small ground station. It is open source, available on github and thingiverse.
The drawback of my dock is simply the fact I needed to solder some cables inside.
I was simple, but not as clean as it could be with the PCB you have just designed!

Please let me know if I can help with changing/providing the dimensions of my dock, if this PCB would fit my dock, that would be awesome!

Buttons are going to work only with WPro58 firmware ( in this configuration (that does not involve storing 1 of 8 states on 3 pins).