DroneMesh PCB for RapidFire

All Products Supports and Mods
Post Reply
Wojked
Posts: 1
Joined: Fri Nov 22, 2019 7:17 pm

Fri Nov 22, 2019 7:22 pm

Hey!

I just saw the video on YouTube about your PCB for rapidfire!
(

I think it has a huge potential, I believe that a cheap DIY dock for Fatshark modules has always been needed!

I have designed a dock I used as a small ground station. It is open source, available on github and thingiverse.
dock_photo_design.jpg
dock_photo1.jpg
The drawback of my dock is simply the fact I needed to solder some cables inside.
dock_photo_wires.jpg
dock_photo_diagram.jpg
I was simple, but not as clean as it could be with the PCB you have just designed!

Please let me know if I can help with changing/providing the dimensions of my dock, if this PCB would fit my dock, that would be awesome!

Note:
Buttons are going to work only with WPro58 firmware (https://github.com/piodabro/WPro58) in this configuration (that does not involve storing 1 of 8 states on 3 pins).


https://www.thingiverse.com/thing:3500798
https://github.com/wojked/fpv-module-dock
Post Reply